This is the third piece in the collection – we’ve covered the Desk, as well as the File Cabinet and now we’re on to the bookcase!
This is a very easy build with minimal materials and it will be completed in no time!
1-1/2″ pocket hole screws 1-1/4″ brad nails Five pieces of [...]
Another beautiful sideboard perfect for entertaining your holiday guests complete with four drawers, a cabinet with a shelf, and concealed wine storage. What’s not to love??
1-1/4″ pocket hole screws 1-1/4″ screws Two sets of hinges Hardware for the doors and large drawer Edge banding for the exposed edges of the [...]
Once again, here is another piece I absolutely love! With a drawer for wine, two smaller drawers for wine (or other beverage) “accessories”, and a large cabinet, there is plenty of storage!
I built this cabinet for myself (out of Purebond plywood!) but made a modification – instead of one wine drawer and [...]
We all know the “measure twice, cut once” rule but we’ve all been there… I know I’ve been there lots of times! I am human and I make mistakes! There, I said it. But then again, it might not be a mistake but a piece of plywood that is just too short for the project [...]
Once again, Thanksgiving is here! It seems that time flies by so quickly! I am so thankful for my readers and those of you who email me with project requests! I am especially thankful for Rayan Turner from The Design Confidential (from whom I got my start) because without her, I would not be able to [...]
I have a child who is a door-slammer. No matter how many times I get on her about it, she still slams every door every time she uses it.
I found cabinet door dampers at the home improvement store. A damper for a cabinet door is a piece that installed at the cabinet opening, where [...]
This is the perfect project for one who is new to woodworking or one just looking for something quick and easy! The actual inspiration piece uses glass clips to hold the glass dividers in place but when I researched them, they were expensive! I created an alternative that would be easy (and much more cost effective) to [...]
I found the prettiest glass votive candle holders at the dollar store. I bought five of them and was instantly inspired to make a holder from a scrap piece of a 2×4 to hold each of these little beauties.
The holes were super-simple to drill and the most time-consuming part (if you want to [...]
Using a router to create decorative edges is a no-brainer… Insert the bit of your choice and go! I have a cabinet I am working on and I made a major faux pas. While I cannot elaborate on the cabinet (it is for a future post), I can elaborate on the mistake and why I [...]
Well, hello there! If you were here for Part 1, we covered the measurements for the cabinet to be built, the cutting of the boards, and the assembly of both the cabinet and door. If you missed it, you can get in on the action by clicking here.
So we have [...]