How to Make Furniture Legs with Plywood

Make Furniture Legs with Plywood? Yes!

When I am working with what I call a “specialty plywood” such as Walnut, Maple, etc., buying 2×2 pieces of that particular species is never part of the budget. Don’t get me wrong, I would love to be able to purchase solid wood other than Oak or Pine but I just can’t afford it. So when I am working with a specialty plywood and I need legs for the project, I make furniture legs with plywood! Unless the project is going to be painted (and I would never paint hardwood!!), this helps with the consistency of the wood species. For instance, I would not use Pine or Oak with Maple, although it may look kind of cool but I would rather go with a more cohesive look. Making my furniture legs from plywood solves this problem!

make furniture legs plywood_SANY2779 copy

Here is what you will need:

  • Plywood
  • Wood glue and 1-1/4″ brad nails
  • Tapering jig, optional
  • 2″ edge banding (<– affiliate link!) & trimmer
  • Sandpaper (I use 150 & 220)

I start by cutting strips of the plywood a little wider than the finished width. For example, the Walnut I am using isn’t quite 3/4″ thick. The plywood measures approximately 11/16″. I cut my strips at 1-5/8″ wide by the length indicated in the plans I’m using.

make furniture legs plywood SANY2775

I spread glue on the face of one piece, then lay another piece on top wiggling it to create suction (so there aren’t as many air spaces in between the pieces) then secure the two pieces together using my brad nailer and 1-1/4″ brad nails.

 make furniture legs plywood SANY2776

I ran the pieces through the table saw setting my rip fence for 1-1/2″ from the blade and trimmed off one side of the raw edges. I then reset the rip fence for 1-3/8″ from the blade (my final width) to trim the other side. This helps square up the pieces and makes a nice finish for edge banding! At this point, a taper can also be cut in the leg using a tapering jig but only on one of the sides with the exposed edges!

make furniture legs plywood SANY2777

 I apply 2″ edge banding to each side with the exposed edges, then trim the excess away.

 make furniture legs plywood SANY2778

I thoroughly sand all areas of the leg. Then I am ready for assembly!

 make furniture legs plywood SANY2779

It is hard to tell that the leg is plywood and not a solid piece of wood!

 make furniture legs plywood SANY2780

So now you know that you can make furniture legs with plywood and it can look like a solid piece! Awesome, right? Need help? Let me know! Contact me at cher {at} designsbystudioc {dot} com!

Originally posted 2013-11-21 08:00:20.

10 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.