How to Build a Wall Pocket

An Easy to Build Project Inspired by Ballard Designs

We can always use a little extra storage, right? Actually, some of us (pointing the finger at myself) could do better with less stuff! These plans are inspired by wall pockets found in the Ballard Designs catalog but are much cheaper! I built this in a little over an hour and used my trusty chalk paint as the finish. I added a couple of bookplates found in the scrapbooking section of my local hobby store to complete the look.

How to Build a Wall Pocket Inspired by Ballard Designs_Finished

A two-pocket hanging will cost about $10 to build. It can also be customized to add additional pockets – Just lengthen the base including the appropriate spacing between pockets.

Materials:

  • Wood glue
  • 1-1/2″ brad nails (<–affiliate link!)
  • Pencil & square
  • Decorative plates for the front
  • Finishing supplies

Lumber:

Cut List:

  • 1 – 1/2″ plywood at 14-1/2″ x 23-1/4″ – Base
  • 4 – 1/2″ plywood at 3-1/2″ x 8-1/4″ – Sides
  • 2 – 1/2″ plywood at 1-3/4″ x 12″ – Bottoms
  • 2 – 1/2″ plywood at 8-1/2″ x 13″ – Fronts

How to Build a Wall Pocket Inspired by Ballard Designs

 

Step One

Cut the piece for the base.

How to Build a Wall Pocket Inspired by Ballard Designs_Pocket Base

Step Two

Cut the pieces for the sides and cut the angles as shown. Draw lines on the base for placement of the sides. Use glue and 1-1/4″ brad nails through the back side of the base to secure.

How to Build a Wall Pocket Inspired by Ballard Designs_Pocket Sides 1

How to Build a Wall Pocket Inspired by Ballard Designs_Pocket Sides 2

Step Three

Cut the pieces for the bottoms. Secure to the base and sides using glue and 1-1/4″ brad nails.

How to Build a Wall Pocket Inspired by Ballard Designs_Pocket Bottom

Step Four

Cut the pieces for the fronts. Cut a 12 degree bevel in each of the longer sides of the fronts as shown. Do not attach to the pocket sides and bottoms yet!

How to Build a Wall Pocket Inspired by Ballard Designs_Pocket Front 1

Step Five

Thoroughly sand the entire assembly, as well as the front pieces. I found it was much easier to prime and paint or stain the wall pockets before the front pieces were attached. Once the paint or stain is dry, attach the front pieces with glue and 1-1/4″ brad nails, then hang on the wall with a couple of screws through the base into a wall stud.

How to Build a Wall Pocket Inspired by Ballard Designs_Pocket Front 2

How to Build a Wall Pocket Inspired by Ballard Designs_Front View

** Please note – these plans are designed and created by me. They are not to be sold without express written consent from me. They can be shared on any site as long as they are credited back to me!

#DIY #woodworking #build

Originally posted 2012-09-14 08:00:22.

5 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.